Prepared according to Annex II of EC Regulation 1907/2006
06. Accidental release measures
Refer to point 13. and for personal protection refer to point 8.
6.1 Personal precautions
Avoid contact with eyes. If applicable, caution - risk of slipping.
6.2 Environmental precautions
If leakage occurs, dam up. Prevent surface and ground-water infiltration, as well as ground penetration.
Prevent from entering drainage system.
6.3 Methods for cleaning up
Collect using absorbant material (e.g. Universal binding medium, sand, kieselguhr, sawdust), and dispose of
according to point 13.
07.
Handling and storage
7.1 Handling
Tips for safe handling:
See point 6.1
Wash hands before breaks and at end of work. General hygiene measures for the handling of chemicals are
applicable. Observe directions on label and instructions for use.
7.2. Storage
Requirements for storage rooms and
containers:
Not to be stored in gangways or stair wells.Store products only unopened, in original packing.
Special storage conditions:
See point 10
Protect from frost.
08. Exposure controls/personal protection
8.1 Exposure limit values
---
8.2 Exposure controls
8.2.1 Occupational exposure controls
Ensure good ventilation. This can be achieved by local suction or general air extraction.
If this is insufficient to maintain the concentration under the WEL or AGW values, suitable breathing protection
should be worn. Applies only if maximum permissible exposure values are listed here. Respiratory
protection:Normally not necessary. Hand protection:Recommended Rubber gloves (EN 374).
Protective PVC gloves (EN 374) Protective Neopren gloves (EN 374). Protective hand cream recommended.
Eye protection:Tight fitting protective goggles (EN 166) with side protection, with danger of projections.
Skin protection:Protective working garments (e.g. safety shoes EN 344, long-sleeved protective working garments)
Additional information on hand protection - No tests have been performed. Selection made for preparations
according to the best available knowledge and information on the ingredients. Selection of materials derived from
glove manufacturer's indications. Final selection of glove material must be made taking the breakthrough times,
permeation rates and degradation into account. Selection of a suitable glove depends not only on the material but
also on other quality characteristics and varies from manufacturer to manufacturer. In the case of preparations the
resistance of glove materials cannot be calculated in advance so it has to be tested before use. The exact
breakthrough time of the glove material can be requested from the protective glove manufacturer and must be
observed.
8.2.2 Environmental exposure controls
n.av.
09. Physical and chemical properties
Physical state:
Colour: White
Odour: Characteristic
pH-value undiluted: 7,2 (20°C)
Boiling point/boiling range (°C): 100
Melting point/melting range (°C): n.av.
Flash point (°C): n.a.
Autoflammability: No
Minimum limit of explosion: n.a.
Maximum limit of explosion: n.a.
Product is not explosive.
Vapour pressure: 23 hPa (20°C)
Density (g/ml): 1,00 (20°C)
Water solubility: Emulsion
Viscosity: Low
Liquid
Printing Date: 26.01.2011 Revision Date: 26.01.2011 Page 2/4
Cockpit Reiniger Matt
(3 pages)
(5 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels